| 01 |
Passed |
| 02 |
Failed |
| 03 |
Not accessible |
| 04 |
Scheduled inspection not ready |
| A5 |
No address posted |
| A6 |
Wrong contractor listed |
| A7 |
Missing required inspections |
| A8 |
Need additional permits |
| A9 |
Call Inspector |
| B0 |
Approved plans not on jobsite |
| B1 |
Manufacturer's installation instructions not on jobsite |
| B2 |
Equipment not installed per manufacturer's instructions |
| B3 |
Piping test was low or faulty gauge |
| 20 |
Gas pipe not complete |
| B4 |
Gas piping installation damaged or incorrect |
| B5 |
Piping material incorrect |
| B6 |
Piping support missing or incorrect |
| B7 |
Piping protection missing or incorrect |
| B8 |
Piping sleeves missing or incorrect |
| B9 |
Piping labels missing or incorrect |
| C0 |
Piping depth incorrect |
| C1 |
Gas Pipe fitting use incorrect |
| C2 |
Gas cock missing or incorrect |
| C3 |
Wrong gas regulator or not on jobsite |
| C4 |
Duct material incorrect |
| C5 |
Duct clearances incorrect |
| C6 |
Duct support incorrect |
| C7 |
Duct installation incorrect |
| C8 |
Duct insulation incorrect |
| C9 |
Commercial grease hood missing or incorrect |
| D0 |
Commercial grease exhaust installation incorrect |
| D1 |
Commercial grease exhaust material incorrect |
| D2 |
Exhaust system missing or incorrect |
| D3 |
Exhaust clearances incorrect |
| D4 |
Exhaust duct material incorrect |
| D5 |
Residential grease exhaust system missing or incorrect |
| D6 |
Dryer exhaust missing or incorrect |
| D7 |
Fire or smoke sensors missing or incorrect |
| D8 |
Fire or smoke stopping incorrect |
| D9 |
Fire or smoke damper installation incorrect |
| E0 |
Chase requirements incorrect |
| E1 |
Seismic requirements incorrect |
| E2 |
Missing equipment |
| 40 |
Equipment protection needed |
| E3 |
Equipment support incorrect |
| E4 |
Equipment access incorrect |
| E5 |
Equipment clearance incorrect |
| E6 |
Equipment platform or catwalk missing or incorrect |
| 44 |
Equipment not vented |
| E7 |
Flue clearances incorrect |
| E8 |
Flue materials incorrect |
| E9 |
Flue Design incorrect |
| F0 |
Flue support incorrect |
| F1 |
Flue termination incorrect |
| 55 |
Need combustion air |
| F2 |
Chimney liner needed or installed incorrectly |
| F3 |
Manufactured flue installation incorrect |
| F4 |
Pan or coil drains missing or incorrect |
| F5 |
Safety pan missing or incorrect |
| F6 |
Pipe insulation at water heater missing or incorrect |
| F7 |
T & P drain missing or incorrect |
| F8 |
Water heater stand missing or incorrect |
| F9 |
Water heater protection missing or incorrect |
| G0 |
Structure not secure |
| G1 |
Energy requirements incorrect |
| G2 |
Fire Code violations |
| G3 |
Registers missing |
| G4 |
Filters missing |
| G5 |
Previous Inspection error |
| G9 |
Approved plan error |
| H0 |
Damage caused by others |
© 2008
